Bishka
Member
Registered:1522501260 Posts: 47
Posted 1552311585
Reply with quote
#1
Would there be any possibility of having the option to close the Bezier Curve? Trying to get the two ends to meet-up exactly is bit off a pain and unless one can get them to meet-up one can't use the fill tools or wand with them. Alternatively the option to snap the spline points to each other, perhaps by holding down the 'S' key (S for snap?) while dragging one of the points, as soon as two points touch, the one being dragged snaps to the stationary point? If it was possible to snap any point to any other, then this option would be more useful than just a simple 'Close Spline' check box. Regards Andrew
kcarlino
Administrator
Registered:1499208671 Posts: 544
Posted 1552387359
Reply with quote
#2
Hi Andrew, It might be a bit tricky with the current algorithm that is used, but we will consider this. Thanks for the suggestion! Ken
Bishka
Member
Registered:1522501260 Posts: 47
Posted 1552758136
Reply with quote
#3
Thanks for the consideration. Bishka